Pressure Washer Nozzle Assembly with a Recessed Tip and Rubber Guard for Car Washing and Detailing
This pressure washer nozzle assembly places the spray tip inside a rubber guard, helping reduce accidental contact between the nozzle and your car's paint during washing. The recessed design keeps the nozzle set back, while the guard arrives pre-assembled around it.
The Mosmatic assembly uses a separate nozzle design that allows the coupler to sit at the end of the wand behind the protector. Select a 25-degree or 40-degree spray angle, then match the orifice size to your pressure washer's requirements. Spray angle determines how water exits the nozzle; orifice size regulates pressure output.
Features
- Recessed spray tip helps reduce accidental nozzle contact with paint.
- Rubber guard comes pre-assembled over the nozzle.
- Separate nozzle assembly allows coupler placement behind the protector at the wand end.
- Two spray angles support selection for your washing setup.
- Thirteen orifice sizes allow selection for a specific pressure washer.
Specifications
- Product type: Pressure Washer Nozzle
- Assembly design: Separate nozzle assembly with recessed tip
- Guard: Pre-assembled rubber guard
- Spray angles: 25 degrees or 40 degrees
- Orifice sizes: 2.0, 2.5, 3.0, 3.5, 4.0, 4.5, 5.0, 5.5, 6.0, 6.5, 7.0, 7.5, 8.0
- Selectable configurations: 26 angle and orifice combinations
Frequently Asked Questions
How does this nozzle assembly help protect paint during car washing?
The nozzle assembly recesses the spray tip inside a rubber guard, helping reduce accidental contact between the nozzle and painted surfaces. The guard comes pre-assembled over the nozzle.
How do I select the spray angle and orifice size?
Choose either a 25-degree or 40-degree spray angle, then select the orifice size required by your pressure washer. The angle determines how water exits the nozzle, while the orifice regulates pressure output; check your washer's nozzle-sizing guidance before selecting.
Where does the coupler sit in this nozzle design?
This separate nozzle assembly allows the coupler to sit at the end of the wand behind the protector. The nozzle itself remains recessed within the guard.